Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE ENGINE ASSEMBLY
  1. Remove the engine (Click here).



4. REMOVE CYLINDER HEAD SUB-ASSEMBLY
  1. Remove the cylinder head (Click here).



5. REMOVE KNOCK SENSOR


    A075662E01
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.