AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Microphone Circuit between Microphone and Radio Receiver |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY) |
Disconnect the R34 radio receiver assembly connector.
Disconnect the M3 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R34-6 (SNS2) - Body ground | Always | Below 1 Ω |
| R34-4 (MACC) - M3-4 (MACC) | Always | Below 1 Ω |
| R34-5 (MIN+) - M3-3 (MCO+) | Always | Below 1 Ω |
| R34-19 (MIN-) - M3-2 (MCO-) | Always | Below 1 Ω |
| R34-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| R34-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| R34-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| R34-18 (SGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK RADIO RECEIVER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| R34-4 (MACC) - Body ground | Ignition switch ACC | 4 to 6 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R34-18 (SGND) - Body ground | Always | Below 1 Ω |
| R34-19 (MIN-) - Body ground | Always | Below 1 Ω |
| *a | Component with harness connected (Radio Receiver Assembly) |
|
| ||||
| OK | |
| 3.CHECK TELEPHONE MICROPHONE ASSEMBLY |
Replace the telephone microphone assembly with a known good one (Click here).
Check that the malfunction disappears.
|
| ||||
| OK | ||
| ||