DTC P2009 Intake Manifold Runner Control Circuit Low (Bank 1) |
DTC P2010 Intake Manifold Runner Control Circuit High (Bank 1) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2009 | Open in VSV for swirl control valve circuit for 0.5 seconds (2 trip detection logic) |
|
| P2010 | Short in VSV for swirl control valve circuit for 0.5 seconds (2 trip detection logic) |
|
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ACTIVATE THE VSV FOR SWIRL CONTROL VALVE) |
![]() |
Connect the intelligent tester to the DLC3.
Disconnect the vacuum hoses from the VSV for swirl control valve.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Swirl Control Valve.
Check the VSV operation when it is operated using the intelligent tester.
| Tester Operation | Specified Condition |
| VSV ON | Air from port E flows out through port F |
| VSV OFF | Air from port E flows out through air filter |
|
| ||||
| NG | |
| 2.INSPECT VACUUM SWITCHING VALVE FOR SWIRL CONTROL VALVE (RESISTANCE) |
![]() |
Disconnect the S9 VSV for swirl control valve connector.
Measure the resistance of the VSV for swirl control valve.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 33 to 39 Ω |
|
| ||||
| OK | |
| 3.INSPECT VACUUM SWITCHING VALVE FOR SWIRL CONTROL VALVE (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the S9 VSV for swirl control valve connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector and body ground.
| Tester Connection | Specified Condition |
| S9-2 - Body ground | 11 to 14 V |
|
| ||||
| NG | |
| 4.CHECK HARNESS AND CONNECTOR (VSV FOR SWIRL CONTROL VALVE - INTEGRATION RELAY) |
![]() |
Remove the integration relay from the engine room junction block .
Disconnect the 1J integration relay connector.
Disconnect the S9 VSV for swirl control valve connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| 1J-5 - S9-2 | Below 1 Ω |
| Tester Connection | Specified Condition |
| 1J-5 - S9-2 | Below 1 Ω |
| 1J-5 or S9-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (VACUUM SWITCHING VALVE FOR SWIRL CONTROL VALVE - ECM) |
![]() |
Disconnect the S9 VSV for swirl control valve connector.
Disconnect the E7 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| S9-1 - SCV (E7-15) | Below 1 Ω |
| Tester Connection | Specified Condition |
| S9-1 or SCV (E7-15) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||