EGR VALVE (w/o Glow Plug Controller) > INSPECTION |
| 1. INSPECT ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/ EGR Cooler) |
![]() |
Inspect the electric EGR control valve.
When a vacuum of 27 kPa (200 mmHg, 7.88 in.Hg) is applied to the diaphragm chamber, check that the shaft rises and that air flows out.
While maintaining the above conditions, check that there are no leaks and that the shaft stays in position.
Check that the valve does not have heavy carbon deposits and is not stuck.
If the result is not as specified, replace the electric EGR control valve.
Inspect the EGR valve position sensor.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (VC) - 2 (E2) | 20°C (68°F) | 2.8 to 7.8 kΩ |
Create a vacuum in the diaphragm chamber.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (EGLS) - 2 (E2) | 20°C (68°F) EGR valve is fully opened | 2.0 to 7.0 kΩ |
| 20°C (68°F) EGR valve is fully closed | 0.1 to 2.5 kΩ |
| 2. INSPECT ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/o EGR Cooler) |
![]() |
Inspect the electric EGR control valve.
When a vacuum of 27 kPa (200 mmHg, 7.88 in.Hg) is applied to the diaphragm chamber, check that the shaft rises and air flows out.
While maintaining the above conditions, check that there are no leaks and that the shaft stays in position.
Check that the valve does not have heavy carbon deposits and is not stuck.
If the result is not as specified, replace the electric EGR control valve.
| 3. INSPECT NO. 2 EGR VALVE ASSEMBLY (w/ EGR Cooler) |
![]() |
When a vacuum of 53.3 kPa (400 mmHg, 15.7 in.Hg) is applied to the diaphragm chamber, check that the valve turns and air flows out.
Maintaining the above conditions, check that there are no leaks and the valve does not return.
Check that the valve does not have heavy carbon deposits and is not stuck.
If the result is not as specified, replace the No. 2 EGR valve.