Home › ENGINE ยท 2KD-FTV › COOLING › RADIATOR

RADIATOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK RADIATOR RESERVOIR CAP SUB-ASSEMBLY


    A112200E04
  1. Measure the valve opening pressure.

    1. If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.

    2. Check that O-ring 1 is not deformed, cracked or swollen.

    3. Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.



    4. A110393E08
    5. When using the cap tester, tilt it more than 30°.
      Text in Illustration 
      *1
      Radiator Reservoir Cap
      *2
      Radiator Cap Tester
      *a
      More than 30°

    6. Pump the cap tester several times, and check the maximum pressure*.

      Pump speed:
      1 pump per second

      *: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Judgment Criterion:
      Item
      Specified Condition
      Standard value
      (for brand-new cap)
      93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi)
      Minimum standard value
      (after using cap)
      79 kPa (0.8 kgf/cm2, 11.4 psi)

      If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.



2. INSPECT FINS FOR BLOCKAGE


A112201
  1. If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.

    NOTICE:
    1. To avoid damaging the fins, the injection direction should be at right angles to the core surface.
    2. If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so maintain the following injection distances.

      Standard Injection Distance:
      Injection Pressure
      Specified Condition
      2942 to 4903 kPa
      (30.0 to 50.0 kgf/cm2, 427 to 711 psi)
      300 mm (11.8 in.)
      4903 to 7845 kPa
      (50.0 to 80.0 kgf/cm2, 711 to 1138 psi)
      500 mm (19.7 in.)

    3. If the fins are bent, straighten them with a screwdriver or pliers.
    4. Do not expose electronic components to water.

  1. Dry the fins with compressed air.