Home › ENGINE · 1KD-FTV › FUEL › FUEL INJECTOR (w/o Glow Plug Controller)

FUEL INJECTOR (w/o Glow Plug Controller) > INSPECTION

for Preparation Click here



1. INSPECT INJECTOR ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    0.42 to 0.52 Ω

    If the result is not as specified, replace the injector assembly.