FUEL SYSTEM (w/ Glow Plug Controller) > ON-VEHICLE INSPECTION |
| 1. INSPECT FOR FUEL LEAK |
Perform the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / Active Test.
Perform the Active Test.
| Intelligent Tester Display | Test Part | Control Range | Diagnostic Note |
| Test the Fuel Leak | Pressurize common rail interior and check for fuel leaks | Stop/Start |
|
| 2. CHECK PRESSURE DISCHARGE VALVE |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
![]() |
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / Utility / Pressure Discharge Valve Check.
![]() |
Press "Next".
![]() |
Press "Next" again to proceed.
![]() |
Select "Close to Open Check".
Press "Next".
Read the value of "Open and Engine OFF".


| *1 | Fuel Press (Always Closed Check) | *2 | Fuel Press (Close to Open Check) |
| *3 | Engine Speed | *4 | Fuel Cut Operation Signal |
| *5 | Pressure Discharge Valve Operation Prohibition | *6 | Pressure Discharge Valve Operation (Always Closed Check) |
| *7 | Pressure Discharge Valve Operation (Close to Open Check) | - | - |
| *a | Fuel Press Recorded Point | *b | Closed (on) |
| *c | Open (on) | - | - |
![]() | Pressure Discharge Valve Operation Start | - | - |
| 3. BLEED AIR FROM FUEL SYSTEM |
![]() |
Using the hand pump mounted on the fuel filter cap, bleed the air from the fuel system. Continue pumping until the pump resistance increases.
Check if the engine starts.
When the engine can be started, proceed to the next step.
If the engine cannot be started, bleed the air again using the hand pump until the hand pump resistance increases (refer to the procedures above). Then start the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Clear the DTCs (Click here).
Start the engine.*1
![]() |
Enter the following menus: Powertrain / Engine / Active Test / Test the Fuel Leak.*2
| *a | Reference (Active Test Operation) |
Perform the following test 5 times with on/off intervals of 10 seconds: Active Test / Test the Fuel Leak.*3
Allow the engine to idle for 3 minutes or more after performing the Active Test for the fifth time.

Enter the following menus: Powertrain / Engine / DTC.
Read Current DTCs.
Clear the DTCs (Click here).
Repeat steps *1 to *3.
Enter the following menus: Powertrain / Engine / DTC.
Read Current DTCs.