MASS AIR FLOW METER (w/ Glow Plug Controller) > INSPECTION |
| 1. PERFORM AIR BLOWING |
![]() |
Intermittently air blow the air flow meter entrance hole with a pressure of approximately 400 to 1000 kPa (4 to 10 kgf/cm2, 60 to 140 psi) for 30 seconds.
| 2. INSPECT MASS AIR FLOW METER |
![]() |
Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.
| *1 | Platinum Hot Wire (Heater) |