Home › BODY ELECTRICAL › WIPER AND WASHER › HEADLIGHT CLEANER SWITCH

HEADLIGHT CLEANER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY


E225762E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (B) - 4 (L)
    Headlight cleaner switch on
    Below 1 Ω
    Headlight cleaner switch off
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Cleaner Switch Assembly)

  1. Connect the positive (+) lead of the battery to terminal 1 (ILL+) and the negative (-) lead to terminal 2 (ILL-).

  1. Check that the headlight cleaner switch assembly illumination comes on.

    OK:
    The headlight cleaner switch assembly illumination comes on.

    If the result is not as specified, replace the headlight cleaner switch assembly.