SFI SYSTEM > Starter Signal Circuit |
| 1.READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
Read the value displayed on the tester when the ignition switch is ON and when the engine is started.
| Ignition Switch Position | Starter Signal |
| ON | Close |
| START | Open |
| Result | Proceed to |
| OK | A |
| NG (for Manual transmission) | B |
| NG (for Automatic transmission) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ECM - IGNITION SWITCH ASSEMBLY) |
Disconnect the ECM connector.
Disconnect the ignition switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E25-8 (STA) - I8-7 (ST2) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E25-8 (STA) or I8-7 (ST2) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the ignition switch assembly connector.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (ECM - PARK/NEUTRAL POSITION SWITCH) |
Disconnect the ECM connector.
Disconnect the park/neutral position switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E25-8 (STA) - N10-5 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E25-8 (STA) or N10-5 - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the park/neutral position switch connector.
|
| ||||
| OK | ||
| ||