Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE STEERING PAD ASSEMBLY



4. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Multi-information Display)


    C238004E01
  1. Disconnect the connectors and detach the 2 clamps.
    Text in Illustration 
    *1
    Pin
    *2
    Clamp

  1. Remove the 2 screws.

  1. Detach the 4 pins and remove the steering pad switch.



5. REMOVE STEERING PAD SWITCH LH (w/o Multi-information Display)

HINT:
Refer to the step "REMOVE STEERING PAD SWITCH ASSEMBLY".