DTC P1001 Fuel Sub Tank Solenoid Duty Control Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1001 |
|
|

| 1.INSPECT FFV RELAY |
![]() |
Remove the FFV relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Battery voltage is applied between terminals 1 and 2 | Below 1 Ω |
Reinstall the FFV relay.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FFV RELAY - SOLENOID VALVE ASSEMBLY) |
Remove the FFV relay from the engine room relay block.
Disconnect the solenoid valve assembly (for fuel injection volume control) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| FFV relay terminal (3) - S24-2 (FFV+) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| FFV relay terminal (3) or S24-2 (FFV+) - Body ground | Always | 10 kΩ or higher |
Reinstall the FFV relay.
Reconnect the solenoid valve assembly (for fuel injection volume control) connector.
|
| ||||
| OK | |
| 3.INSPECT SOLENOID VALVE ASSEMBLY (FOR FUEL INJECTION VOLUME CONTROL) |
Inspect the solenoid valve assembly (for fuel injection volume control) (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SOLENOID VALVE ASSEMBLY (FOR INJECTION VOLUME CONTROL) - ECM) |
Disconnect the solenoid valve assembly (for injection volume control) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S24-1 (FFV-) - E24-18 (DSSV) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| S24-1 (FFV-) or E24-18 (DSSV) - Body ground | Always | 10 kΩ or higher |
Reconnect the solenoid valve assembly (for injection volume control) connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 5.CHECK SUB TANK FUEL PUMP CONTROL CIRCUIT |
Check the sub tank fuel pump control circuit (Click here).
|
| ||||
| OK | ||
| ||