DTC P100B Open in Sub Fuel Tank VSV Control Circuit |
DTC P100C Short in Sub Fuel Tank VSV Control Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P100B |
|
|
| P100C |
|
|
| 1.INSPECT FFV RELAY |
![]() |
Remove the FFV relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Battery voltage is applied between terminals 1 and 2 | Below 1 Ω |
Reinstall the FFV relay.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FFV RELAY - SOLENOID VALVE ASSEMBLY (FOR FUEL CUT CONTROL)) |
Remove the FFV relay from the engine room relay block.
Disconnect the solenoid valve assembly (for fuel cut control) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| FFV relay terminal (3) - S23-2 (SFC+) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| FFV relay terminal (3) or S23-2 (SFC+) - Body ground | Always | 10 kΩ or higher |
Reinstall the FFV relay.
Reconnect the solenoid valve assembly (for fuel cut control) connector.
|
| ||||
| OK | |
| 3.INSPECT SOLENOID VALVE ASSEMBLY (FOR FUEL CUT CONTROL) |
Inspect the solenoid valve assembly (for fuel cut control) (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SOLENOID VALVE ASSEMBLY (FOR FUEL CUT CONTROL) - ECM) |
Disconnect the solenoid valve assembly (for fuel cut control) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S23-1 (SFC-) - E24-1 (SSV) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| S23-1 (SFC-) or E24-1 (SSV) - Body ground | Always | 10 kΩ or higher |
Reconnect the solenoid valve assembly (for fuel cut control) connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 5.CHECK SUB TANK FUEL PUMP CONTROL CIRCUIT |
Check the sub tank fuel pump control circuit (Click here).
|
| ||||
| OK | ||
| ||