Home › ENGINE ยท 2TR-FBE › FUEL › FUEL JET

FUEL JET > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY
  1. Apply gasoline to 4 new O-rings. Then install the 4 O-rings to the No. 1 fuel pipe sub-assembly.



    A241648E01
  1. Set the No. 1 fuel pipe sub-assembly against the 4 protrusions and install it with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. Set the areas of the fuel pipe marked with white paint marks against the protrusions of the intake manifold from the directions indicated by the arrows in the illustration.
    2. Make sure the fuel pipe does not become deformed when installing it.

  1. Connect the fuel hose.



2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
(Click here)


3. INSPECT FOR FUEL LEAK (for Fuel Sub Tank)
  1. Start the engine.

    NOTICE:
    Perform the inspection while the engine is cold.
    The fuel pump operates only for a certain amount of time when the coolant temperature is 20°C (68°F) or less and the learned ethanol concentration is 85% or more.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.