Home › ENGINE ยท 2TR-FBE › FUEL › FUEL JET

FUEL JET > INSPECTION

for Preparation Click here



1. INSPECT NO. 1 FUEL PIPE SUB-ASSEMBLY


  1. Visually check the jet of the No. 1 fuel pipe sub-assembly.



      A230920
    1. Inspect the jet.

      HINT:
      The inner diameter of the jet is approximately 0.56 mm (0.0220 in.).



    2. A239176E01
    3. If the No. 1 fuel pipe sub-assembly passages are clogged or dirty, clean them. After blowing air in both directions (into A and into B) as indicated in the illustration, visually check the jet of the No. 1 fuel pipe sub-assembly again.
      If the No. 1 fuel pipe sub-assembly passages remain clogged or dirty, replace the No. 1 fuel pipe sub-assembly.