Home › ENGINE ยท 2TR-FBE › FUEL › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank)

FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY
  1. Install a new fuel suction tube set gasket.



    A238198E01
  1. Install the fuel suction plate sub-assembly to the auxiliary fuel tank as shown in the illustration.



    A238199E01
  1. While holding the fuel suction plate sub-assembly by hand to prevent it from tilting, align the mark on a new fuel pump gauge retainer with the start mark on the auxiliary fuel tank and tighten the fuel pump gauge retainer 720° by hand.

    NOTICE:
    Perform this step by hand. Do not use any tools.



2. CONNECT NO. 4 FUEL HOSE
  1. Connect the No. 4 fuel hose.

  1. Connect the fuel sender gauge connector.



3. ADD FUEL


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. INSPECT FOR FUEL LEAK (for Fuel Sub Tank)
  1. Start the engine.

    NOTICE:
    Perform the inspection while the engine is cold.
    The fuel pump operates only for a certain amount of time when the coolant temperature is 20°C (68°F) or less and the learned ethanol concentration is 85% or more.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.