Home › ENGINE · 2TR-FBE › FUEL › FUEL PUMP (for Fuel Sub Tank)

FUEL PUMP (for Fuel Sub Tank) > INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω

      If the result is not as specified, replace the fuel pump.

  1. Check fuel pump operation.

    1. Apply battery voltage to both terminals. Check that the pump operates.

      NOTICE:
      1. This test must be done quickly (for less than 10 seconds) to prevent the coil from burning out.
      2. Keep the fuel pump as far away from the battery as possible.
      3. Always do the switching at the battery.

      If the motor does not operate, replace the fuel pump.