Home › ENGINE ยท 2TR-FBE › FUEL › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank)

FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. DRAIN FUEL


4. DISCONNECT NO. 4 FUEL HOSE


    A237770
  1. Disconnect the fuel sender gauge connector.



    A237775
  1. Disconnect the No. 4 fuel hose.



5. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    A238197
  1. Remove the fuel pump gauge retainer.

    NOTICE:
    Perform this step by hand. Do not use any tools.

  1. Remove the fuel suction plate sub-assembly.



    A233435
  1. Remove the fuel suction tube set gasket.