Home › ENGINE ยท 2TR-FBE › FUEL › SOLENOID VALVE (for Fuel Injection Volume Control)

SOLENOID VALVE (for Fuel Injection Volume Control) > INSTALLATION

for Preparation Click here



1. INSTALL SOLENOID VALVE ASSEMBLY
  1. Install the solenoid valve with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Install the solenoid valve assembly with the 2 nuts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Connect the 2 fuel hoses and connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. INSPECT FOR FUEL LEAK (for Fuel Sub Tank)
  1. Start the engine.

    NOTICE:
    Perform the inspection while the engine is cold.
    The fuel pump operates only for a certain amount of time when the coolant temperature is 20°C (68°F) or less and the learned ethanol concentration is 85% or more.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.