Home › ENGINE ยท 2TR-FBE › FUEL › FUEL SUB TANK

FUEL SUB TANK > INSTALLATION

for Preparation Click here



1. INSTALL BREATHER TUBE FUEL HOSE


    A241615E01
  1. Align the paint mark and protrusion as shown in the illustration and install the breather tube fuel hose, and then tighten the hose clamp in the position shown in the illustration.



2. INSTALL FUEL TANK FILLER PIPE


    A241614E01
  1. Align the protrusion and paint mark as shown in the illustration and install the fuel tank filler pipe, and then tighten the hose clamp in the position shown in the illustration.



3. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY
  1. Install a new fuel suction tube set gasket.



    A238198E01
  1. Install the fuel suction plate sub-assembly to the auxiliary fuel tank as shown in the illustration.



    A238199E01
  1. While holding the fuel suction plate sub-assembly by hand to prevent it from tilting, align the mark on a new fuel pump gauge retainer with the start mark on the auxiliary fuel tank and tighten the fuel pump gauge retainer 720° by hand.

    NOTICE:
    Perform this step by hand. Do not use any tools.



4. INSTALL CHECK VALVE GASKET
  1. Apply a light coat of gasoline to a new check valve gasket, and then install the gasket.



5. INSTALL FUEL PUMP
  1. Insert the fuel pump.



6. INSTALL NO. 2 FUEL TUBE SUB-ASSEMBLY


    A239220E01
  1. Connect the No. 2 fuel tube sub-assembly, and then attach the clamp.

    NOTICE:
    Install the marked area of the No. 2 fuel tube sub-assembly to the clamp.

  1. Connect the fuel pump connector.



7. INSTALL FUEL TANK CAP COVER
  1. Install the fuel tank cap cover with a new tie wrap.



8. INSTALL FUEL TANK CAP ASSEMBLY


9. INSTALL FUEL TANK FILLER PIPE SUPPORT


    A239224
  1. Install the No. 1 fuel tank filler pipe support and No. 2 fuel tank filler pipe support as shown in the illustration.



10. INSTALL SOLENOID VALVE ASSEMBLY
  1. Install the solenoid valve assembly with the bolt.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Connect the hose.



11. INSTALL AUXILIARY FUEL TANK ASSEMBLY
  1. Install the auxiliary fuel tank assembly with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

    NOTICE:
    1. Do not drop the auxiliary fuel tank.
    2. Do not damage the piping or wiring.

  1. Connect the No. 2 fuel tank filler tube.

  1. Connect the fuel pump connector.

  1. Connect the No. 4 fuel hose.

  1. Connect the fuel sender gauge connector.

  1. Connect the connector and No. 3 fuel hose.



12. ADD FUEL


13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



14. INSPECT FOR FUEL LEAK (for Fuel Sub Tank)
  1. Start the engine.

    NOTICE:
    Perform the inspection while the engine is cold.
    The fuel pump operates only for a certain amount of time when the coolant temperature is 20°C (68°F) or less and the learned ethanol concentration is 85% or more.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.