Home › ENGINE ยท 2TR-FBE › FUEL › FUEL SUB TANK

FUEL SUB TANK > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE AUXILIARY FUEL TANK ASSEMBLY


    A241609
  1. Disconnect the connector and No. 3 fuel hose.



    A237770
  1. Disconnect the fuel sender gauge connector.



    A237775
  1. Disconnect the No. 4 fuel hose.



    A237771
  1. Disconnect the fuel pump connector.



    A237772
  1. Disconnect the No. 2 fuel tank filler tube.



    A237776
  1. Remove the 2 bolts and auxiliary fuel tank assembly.

    NOTICE:
    1. Do not drop the auxiliary fuel tank.
    2. Do not damage the piping or wiring.



4. REMOVE SOLENOID VALVE ASSEMBLY


    A241610
  1. Disconnect the hose.

  1. Remove the bolt and solenoid valve assembly.



5. REMOVE FUEL TANK FILLER PIPE SUPPORT


    A239223
  1. Remove the No. 1 fuel tank filler pipe support and No. 2 fuel tank filler pipe support.



6. REMOVE FUEL TANK CAP ASSEMBLY


7. REMOVE FUEL TANK CAP COVER


    A239225
  1. Remove the tie wrap and fuel tank cap cover.



8. DRAIN FUEL


9. REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY


    A237771
  1. Disconnect the fuel pump connector.



    A237778
  1. Detach the clamp, and then disconnect the No. 2 fuel tube sub-assembly.

    HINT:
    1. A filter is built into the No. 2 fuel tube.
    2. If the No. 2 fuel tube is clogged, replace it with a new one.



10. REMOVE FUEL PUMP


    A237779
  1. Pull out the fuel pump.



11. REMOVE CHECK VALVE GASKET


    A237780
  1. Remove the check valve gasket.



12. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    A238197
  1. Remove the fuel pump gauge retainer.

    NOTICE:
    Perform this step by hand. Do not use any tools.

  1. Remove the fuel suction plate sub-assembly.



    A233435
  1. Remove the fuel suction tube set gasket.



13. REMOVE FUEL TANK FILLER PIPE


    A241614
  1. Loosen the hose clamp, and then remove the fuel tank filler pipe.



14. REMOVE BREATHER TUBE FUEL HOSE


    A241615
  1. Loosen the hose clamp, and then remove the breather tube fuel hose from the fuel tank sub-assembly.