DTC P1605 Rough Idling |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| - | When the accelerator pedal is fully closed and the engine is idling, the speed of a specific cylinder is low for 2 to 10 seconds (1 trip detection logic). |
|
| DTC No. | Data List |
| P1605 |
|
| In order for idling to be stable, glow system operation, fuel system operation and compression sufficient to maintain the target idling speed are necessary. |
| Glow system |
The following malfunctions may be present in the glow system.
Engine coolant temperature sensor malfunction.
Glow plug malfunction.
Glow control unit malfunction.
| Fuel system |
The following malfunctions may be present in the fuel system.
Fuel leakage.
Problem with injector assemblies.
Problem with fuel supply pump assembly.
Air in fuel pipe.
| Engine assembly |
The following malfunctions may be present in the engine assembly.
Insufficient compression.
| 1.DTC OUTPUT (RECORD STORED DTC AND FREEZE FRAME DATA (PROCEDURE 1)) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Record the stored DTC and freeze frame data.
| NEXT | |
| 2.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1605) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| P1605 is output | A |
| P1605 and other DTCs are output | B |
|
| ||||
| A | |
| 3.DETERMINE CAUSE OF PROBLEM (CHECK FREEZE FRAME DATA) |
Determine the cause of the problem based on the freeze frame data recorded in Procedure 1.
| Judgment of Data List Values | Problem Cause | Diagnosis Note |
| Any of Rough Idle #1 to #4 in the freeze frame data is ON | Injector assembly | If the cylinder that displays Rough Idle ON also has a value of more than 3.0 mm3/st for Injection Feedback Val, improper combustion in that cylinder is suspected.
|
| Judgment of Data List Values | Problem Cause | Diagnosis Note |
| Any of Injection Feedback Val #1 to #4 in the freeze frame data is more than 3.0 mm3/st | Injector assembly | If the cylinder that displays Rough Idle ON also has a value of more than 3.0 mm3/st for Injection Feedback Val, improper combustion in that cylinder is suspected. |
| Judgment of Data List Values | Problem Cause | Normal Condition | Diagnosis Note |
| Any values for "Injector Leaking Count #1 to #4" in the Freeze Frame Data display 1 or more |
| 0 | When the counter is 1 or more, the problem may have occurred due to foreign matter in the fuel system. Replace the fuel filter, etc. and perform repairs according to the troubleshooting procedure. |
| Judgment of Data List Values | Problem Cause | Normal Condition | Diagnosis Note |
| Any values for "i-ART Learning Status History #1 to #4" in the Freeze Frame Data display 1 Trip or more |
| 0 Trip | When the counter is 1 or more, the problem may have occurred due to foreign matter in the fuel system. Replace the fuel filter, etc. and perform repairs according to the troubleshooting procedure. |
| NEXT | ||
| ||