DTC P1605 Rough Idling |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| - | The engine speed drops to less than 400 rpm (1 trip detection logic). |
|
| DTC No. | Data List |
| P1605 |
|
| In order for idling to be stable, glow system operation, fuel system operation and compression sufficient to maintain the target idling speed are necessary. |
| Glow system |
The following malfunctions may be present in the glow system.
Engine coolant temperature sensor malfunction.
Glow plug malfunction.
Glow relay malfunction.
| Fuel system |
The following malfunctions may be present in the fuel system.
Fuel leakage.
Problem with injector assemblies.
Problem with fuel supply pump assembly.
Air in fuel pipe.
| Engine assembly |
The following malfunctions may be present in the engine assembly.
Insufficient compression.
| 1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1605) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P1605 is output | A |
| P1605 and other DTCs are output | B |
|
| ||||
| A | ||
| ||