Home › SECURITIES › ENGINE IMMOBILISER › TRANSPONDER KEY AMPLIFIER

TRANSPONDER KEY AMPLIFIER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE STEERING COLUMN LOWER COVER


    C238860
  1. Remove the 3 screws and lower cover.



4. REMOVE STEERING COLUMN UPPER COVER


    C238860
  1. Remove the 3 screws and lower cover.



5. REMOVE TRANSPONDER KEY AMPLIFIER


    G034347E02
  1. Using a screwdriver, widen the claw attached to the upper bracket by approximately 1.0 mm (0.039 in.).

  1. Pull out the transponder key amplifier with the claw open.

  1. Disconnect the transponder key amplifier connector.