Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR

ULTRASONIC SENSOR > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER COVER
  1. Remove the rear bumper cover (Click here).



2. REMOVE NO. 3 LUGGAGE ROOM WIRE


E225420
  1. Disconnect the 2 ultrasonic sensor connectors.

  1. Detach the 3 clamps and remove the luggage room wire from the bumper cover.



3. REMOVE NO. 1 ULTRASONIC SENSOR

HINT:
Use the same procedure for both No. 1 ultrasonic sensors.

  1. Disconnect the connector.



    E225418
  1. While pushing down on the lever with a finger to release the claw on the top of the sensor, detach the claw on the other side to remove the No. 1 ultrasonic sensor.

    HINT:
    The type of claw on the top and the type of claw on the bottom of the sensor are different. Observe the claws carefully before removing the sensor.



4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure for both No. 1 ultrasonic sensor retainers.



    E225427
  1. Detach the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.