Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > OPERATION CHECK

for Preparation Click here



DETECTION RANGE MEASUREMENT AND INDICATOR CHECK
  1. Turn the ignition switch ON.

  2. Move the shift lever to R.

    NOTICE:
    Apply the parking brake securely so that the vehicle does not move.

  3. Turn the back sonar or clearance sonar switch on.



  4. Move a φ 60 mm (2.36 in.) pole around the sensors to measure the detection ranges of the sensors.


    E171457E02

    NOTICE:
    The measured detection ranges are for a φ 60 mm (2.36 in.) pole. The detection ranges for walls and other obstacles are different.



  5. Check the sounding of the buzzer when the No. 1 ultrasonic sensors detect an obstacle.

    Operation Condition 
    Ignition Switch
    Back Sonar or Clearance Sonar Switch
    Shift Lever
    ON
    On
    R



    1. Check that the buzzer sounds with the back sonar or clearance sonar switch on as shown in the illustration.


      E168773E01

      *1: A φ 60 mm (2.36 in.) pole is used as an obstacle.
      *2: A wall is used as an obstacle.

      HINT:
      Since sound waves are used for the detection range measurement, the detection ranges may slightly vary due to the outside air temperature.


CHECK INITIAL CHECK FUNCTION


    E168775E03
  1. Turn the ignition switch ON and turn the back sonar or clearance sonar switch on. After approximately 0.4 seconds, check that the buzzer sounds for approximately 1 +/-0.3 seconds.



  2. Check that the buzzer does not sound as shown in the illustration below.


    E168776E02

    HINT:
    1. If the system detects an open in any sensor circuit, or any sensor does not work (unable to detect because the sensor is wet or frozen), the buzzer operates as shown in the illustration above.
    2. If the buzzer sounds due to a sensor or circuit malfunction, turning the ignition switch off and then ON will return the system to normal if the malfunction is no longer present.