Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Clearance Sonar Main Switch Circuit

for Preparation Click here


DESCRIPTION

When the back sonar or clearance sonar switch is turned on, an ON signal is sent to the clearance warning ECU, and the TOYOTA parking assist-sensor system starts operating.

WIRING DIAGRAM


E168858E06


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG&GAUGE)
  1. Remove the ECU-IG&GAUGE fuse from the driver side junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG&GAUGE fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY


    E168863E03
  1. Remove the back sonar or clearance sonar switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (IG) - 4 (ECU)
    Back sonar or clearance sonar switch on
    Below 1 Ω
    3 (IG) - 4 (ECU)
    Back sonar or clearance sonar switch off
    10 kΩ or higher



NG
REPLACE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (BACK SONAR OR CLEARANCE SONAR SWITCH - CLEARANCE WARNING ECU)


    E169219E03
  1. Disconnect the B15 back sonar or clearance sonar switch assembly connector.



    E149933E66
  1. Disconnect the C25 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    B15-3 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    B15-3 (IG) - Body ground
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B15-4 (ECU) - C25-10 (IG)
    Always
    Below 1 Ω
    B15-4 (ECU) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BODY GROUND)


    E149933E67
  1. Disconnect the C25 clearance warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C25-21 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)