Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Speed Signal Circuit

for Preparation Click here


DESCRIPTION

The clearance warning ECU receives the vehicle speed signal from the combination meter assembly.

WIRING DIAGRAM


E168777E04


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY (SPEEDOMETER)
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.CHECK CLEARANCE WARNING ECU ASSEMBLY
E168778E02
  1. Using an oscilloscope, check the waveform.
    Measurement Condition 
    Item
    Content
    Tester Connection
    C25-3 (SPD) - Body ground
    Tool Setting
    5 V/DIV., 10 msec./DIV.
    Condition
    Vehicle driven at approximately 20 km/h (12 mph)

    OK:
    Correct waveform is as shown.



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER)


    E149933E64
  1. Disconnect the C25 clearance warning ECU connector.



    E168859E01
  1. Disconnect the C10 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C25-3 (SPD) - C10-6
    Always
    Below 1 Ω
    C25-3 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)