TOYOTA PARKING ASSIST-SENSOR SYSTEM > Speed Signal Circuit |

| 1.CHECK COMBINATION METER ASSEMBLY (SPEEDOMETER) |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK CLEARANCE WARNING ECU ASSEMBLY |
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | C25-3 (SPD) - Body ground |
| Tool Setting | 5 V/DIV., 10 msec./DIV. |
| Condition | Vehicle driven at approximately 20 km/h (12 mph) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER) |
![]() |
Disconnect the C25 clearance warning ECU connector.
![]() |
Disconnect the C10 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C25-3 (SPD) - C10-6 | Always | Below 1 Ω |
| C25-3 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||