TOYOTA PARKING ASSIST-SENSOR SYSTEM > Park / Neutral Position Switch Circuit |

| 1.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Remove the park/neutral position switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (RL) - 2 (RB) | Shift lever on R | Below 1 Ω |
| 1 (RL) - 2 (RB) | Shift lever not on R | 10 kΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (A340F) | B |
| NG (A750F) | C |
| NG (A343E) | D |
| NG (A343F) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - CLEARANCE WARNING ECU) |
![]() |
Disconnect the N1 park/neutral position switch assembly connector.
![]() |
Disconnect the C25 clearance warning ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| N1-2 (RB) - Body ground | Ignition switch ON | 11 to 14 V |
| N1-2 (RB) - Body ground | Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N1-1 (RL) - C25-13 (RL) | Always | Below 1 Ω |
| N1-1 (RL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||