Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Park / Neutral Position Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit sends the park/neutral position switch assembly signals to the clearance warning ECU.

WIRING DIAGRAM


E168779E11


INSPECTION PROCEDURE

1.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
E149961E11
  1. Remove the park/neutral position switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (RL) - 2 (RB)
    Shift lever on R
    Below 1 Ω
    1 (RL) - 2 (RB)
    Shift lever not on R
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (A340F)
    B
    NG (A750F)
    C
    NG (A343E)
    D
    NG (A343F)
    E



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

D
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

E
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)
A


2.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - CLEARANCE WARNING ECU)


    E168861E03
  1. Disconnect the N1 park/neutral position switch assembly connector.



    E149933E63
  1. Disconnect the C25 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    N1-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V
    N1-2 (RB) - Body ground
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N1-1 (RL) - C25-13 (RL)
    Always
    Below 1 Ω
    N1-1 (RL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)