Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Back-up Light Circuit

for Preparation Click here


DESCRIPTION

This circuit sends the back-up light switch assembly signals to the clearance warning ECU.

WIRING DIAGRAM


E168779E12


INSPECTION PROCEDURE

1.INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
E169221E01
  1. Remove the back-up light switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Shift lever on R
    Below 1 Ω
    1 - 2
    Shift lever not on R
    10 kΩ or higher



NG
REPLACE BACK-UP LIGHT SWITCH ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH - CLEARANCE WARNING ECU)


    E169220E01
  1. Disconnect the B1 back-up light switch assembly connector.



    E149933E63
  1. Disconnect the C25 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    B1-2 - Body ground
    Ignition switch ON
    11 to 14 V
    B1-2 - Body ground
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B1-1 - C25-13 (RL)
    Always
    Below 1 Ω
    B1-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)