TOYOTA PARKING ASSIST-SENSOR SYSTEM > Back-up Light Circuit |

| 1.INSPECT BACK-UP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the back-up light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Shift lever on R | Below 1 Ω |
| 1 - 2 | Shift lever not on R | 10 kΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (for R150F / R151F) | B |
| NG (for R150 / R151) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH - CLEARANCE WARNING ECU) |
![]() |
Disconnect the B1 back-up light switch assembly connector.
![]() |
Disconnect the C25 clearance warning ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| B1-2 - Body ground | Ignition switch ON | 11 to 14 V |
| B1-2 - Body ground | Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B1-1 - C25-13 (RL) | Always | Below 1 Ω |
| B1-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||