Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the seat wire connector under the seat.

  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the rearmost position.



    B211295E01
  1. Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.



    B211294E01
  1. Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



2. INSTALL SEAT TRACK COVER LH


    B211321E01
  1. Attach the 2 claws in the order shown in the illustration to install the seat track cover LH.

    NOTICE:
    Be careful not to damage the claws.



3. INSTALL INNER SEAT TRACK BRACKET COVER LH


    B211322E01
  1. Attach the 2 claws in the order shown in the illustration to install the inner seat track bracket cover LH.

    NOTICE:
    Be careful not to damage the claws.



4. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Install the front seat headrest assembly.



5. CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)


6. INSPECT FRONT SEAT ASSEMBLY
(Click here)