Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION ANTENNA

NAVIGATION ANTENNA > INSPECTION



1. INSPECT NAVIGATION ANTENNA ASSEMBLY
  1. Temporarily replace the navigation antenna assembly with a new or normally functioning one.

    OK:
    Malfunction disappears.

    If the result is not as specified, replace the navigation antenna assembly.



2. INSPECT NO. 1 NAVIGATION ANTENNA CORD SUB-ASSEMBLY


    E246993E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A (Core wire) - B (Core wire)
    Always
    Below 1 Ω
    A (Shield) - B (Shield)
    Always
    Below 1 Ω
    A (Core wire) - A (Shield) or B (Core wire) - B (Shield)
    Always
    10 kΩ or higher

    If the result is not as specified, replace the No. 1 navigation antenna cord sub-assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 navigation antenna cord sub-assembly)
    *1
    Core wire
    *2
    Shield