FRONT POWER SEAT MOTOR ASSEMBLY (for Rear Lifter) > INSTALLATION |
| 1. INSTALL POWER SEAT MOTOR ASSEMBLY (for Rear Lifter) |
![]() |
Using a 4 mm socket hexagon wrench, install the power seat motor assembly (for Rear Lifter) with the 2 bolts.
Clean the threads of the "TORX" bolt for the adjust screw with non-residue solvent (when reusing the "TORX" bolt).
Apply adhesive to the threads of the "TORX" bolt for the adjust screw (when reusing the "TORX" bolt).
| *1 | Adjust Screw |
Using a T40 "TORX" socket wrench, install the "TORX" bolt.
Connect the connector.
Using a T40 "TORX" socket wrench, install the tilt rod with the 2 "TORX" bolts.
Install the nut.
Install the seat cushion frame with the 4 bolts.
Attach the 4 clamps indicated by the arrows in the illustration to install the seat cushion spring.
w/o Front Seat Side Airbag:
Attach the 2 wire harness clamps.
w/ Front Seat Side Airbag:
Attach the 3 wire harness clamps.

| *A | w/o Front Seat Side Airbag | *B | w/ Front Seat Side Airbag |
| 2. INSTALL FRONT SEAT CUSHION COVER WITH PAD |
Attach the hooks to install the front seat cushion cover with pad.
Bend the 2 front seat cushion frame claws downward.
![]() |
Using hog ring pliers, attach the rubber bands of the separate type front seatback cover to the seat cushion spring with new hog rings.
| *1 | Hog Ring Pliers |
| 3. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH |
![]() |
Install the buckle cover.
Install the front seat inner belt assembly with the nut.
Connect the connector and attach the 3 clamps.
| 4. INSTALL FRONT SEAT INNER CUSHION SHIELD LH |
Pass the wire harness of the front seat inner belt assembly below the claw and into the front seat inner cushion shield LH.

![]() |
Attach the claw to temporarily install the front seat inner cushion shield LH.
![]() |
Attach the guide and claw.
Install the screw.
| 5. INSTALL FRONT POWER SEAT SWITCH LH |
![]() |
Connect the connector.
Install the front power seat switch LH with the 3 screws.
| 6. INSTALL FRONT SEAT CUSHION SHIELD LH WITH FRONT INNER NO. 1 SEAT CUSHION SHIELD LH |
Attach the claw and guide to install the front seat cushion shield LH with the front inner No. 1 seat cushion shield LH.
Install the 3 screws.
Install the 2 screws.
| 7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
![]() |
Attach the 4 claws to install the slide and vertical power seat switch knob.
| 8. INSTALL RECLINING POWER SEAT SWITCH KNOB |
![]() |
Attach the 2 claws to install the reclining power seat switch knob.
| 9. INSTALL FRONT SEAT ASSEMBLY |
| 10. INSPECT FRONT SEAT ASSEMBLY |