DTC P1603 Engine Stall History |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1603 | After monitoring for startability problems (P1604) finishes and 5 seconds or more elapse after starting the engine, the engine stops for 0.5 seconds or more (the engine speed drops to 200 rpm or less) without the ignition switch being operated (1 trip detection logic) |
|
| 1.CHECK FOR ANY OTHER DTCS OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P1603 and/or P1605 is output | A |
| DTC P1603 and/or P1605 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Check the following freeze frame data to see if the engine was cold or warm when the freeze frame data was recorded.
| Coolant Temp |
| Initial Engine Coolant Temp |
| Initial Intake Air Temp |
| Engine Run Time |
Check the following freeze frame data to see if the vehicle was idling, cruising, decelerating, accelerating, starting off, or stopped.
| Engine Speed |
| Vehicle Speed |
| Throttle Sensor Position |
| Throttl Sensor #2 Volt % |
| Accel Sens. No. 1 Volt % |
| Accel Sens. No. 2 Volt % |
| Neutral Position SW Signal |
| Stop Light Switch |
| Closed Throttle Position SW |
| Throttle Sensor Position |
Check the following freeze frame data to see the gear and lock-up state recorded when the engine stalled.
| Shift Status |
| Lock Up |
Check the following freeze frame data to see the engine load and electrical load when the freeze frame data was recorded.
| Calculate Load |
| Electrical Load Signal |
| A/C Signal |
| Power Steering Signal |
Check the following freeze frame data to see the purge VSV operation status when the freeze frame data was recorded.
| EVAP (Purge) VSV |
Check the following freeze frame data to see information related to engine idling from when the freeze frame data was recorded.
| Shift SW Status (P Range) |
| Shift SW Status (N Range) |
Check the following freeze frame data to see the air fuel ratio recorded when the engine stalled.
| Short FT #1 |
| Long FT #1 |
| AF Lambda B1S1 |
Check the following freeze frame data to see the ignition timing recorded when the engine stalled.
| IGN Advance |
| Knock Correct Learn Value |
Check the following freeze frame data to see the FFV (Flexible Fuel Vehicle) information recorded when the engine stalled.
| Alcohol Feedback Value |
| Alc FB Val bfr F/Crrctn by Stall |
| Trip aft F/Crrctn by Stall |
| Fuel Dilution Estimate |
Use this information to perform a simulation test.
Compare the "Normal Condition" in the Data List (reference values) with the freeze frame data listed above and with the simulation test results to determine the problem cause.
| Result | Proceed to |
| The problem cause can be determined | A |
| The problem cause cannot be determined | B |
|
| ||||
| A | ||
| ||