NAVIGATION SYSTEM > Navigation Receiver Assembly Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the N8 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N8-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N8-4 (B) - Body ground | Always | 11 to 14 V |
| N8-3 (ACC) - Body ground | Ignition switch ON (ACC) | 11 to 14 V |
| N8-3 (ACC) - Body ground | Ignition switch off | Below 1 V |
| *a | Front view of wire harness connector (to Navigation Receiver Assembly) |
|
| ||||
| OK | ||
| ||