1GR-FE CHARGING > TORQUE SPECIFICATIONS |
| Part Tightened | N*m | kgf*cm | ft.*lbf | |
| Generator x V-ribbed belt tensioner | 43 | 438 | 32 | |
| Generator wire x Generator | 9.8 | 100 | 87 in.*lbf | |
| V-bank cover sub-assembly x Bracket | 7.5 | 76 | 66 in.*lbf | |
| Generator rectifier end frame x Drive end frame | 4.5 | 46 | 40 in.*lbf | |
| Rectifier holder x Generator rectifier end frame | 2.0 | 20 | 18 in.*lbf | |
| Voltage regulator assembly x rectifier holder | 2.0 | 20 | 18 in.*lbf | |
| Generator brush holder assembly x Generator rectifier end frame | 2.0 | 20 | 18 in.*lbf | |
| Generator rear end cover x Generator rectifier end frame | for bolt | 3.9 | 40 | 34 in.*lbf |
| for nut | 4.4 | 45 | 39 in.*lbf | |
| Terminal insulator x Rectifier holder | 4.1 | 42 | 36 in.*lbf | |
| Generator pulley x Generator assembly | 133 | 1,356 | 98 | |
| Part Tightened | N*m | kgf*cm | ft.*lbf | |
| Generator x V-ribbed belt tensioner | 43 | 438 | 32 | |
| Generator wire x Generator | for nut | 9.8 | 100 | 87 in.*lbf |
| for bolt | 13 | 127 | 9 | |
| Retainer plate x Generator drive end frame | 3.1 | 35 | 30 in.*lbf | |
| Generator stater sub-assembly with rectifier x Generator drive end frame | 4.3 | 44 | 38 in.*lbf | |
| Voltage regulator sub-assembly x Generator stater sub-assembly with rectifier | for screw A | 2.2 | 22 | 19 in.*lbf |
| for screw B | 1.2 | 12 | 11 in.*lbf | |
| Generator rear end cover x Generator stater sub-assembly with rectifier | for nut A | 19 | 194 | 14 |
| for nut B | 12 | 122 | 9 | |
| for screw | 2.4 | 24 | 21 in.*lbf | |