DTC P245C EGR Cooler Bypass Control Circuit Low |
DTC P245D EGR Cooler Bypass Control Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 3 seconds | Open or short in the vacuum switching valve (for EGR bypass valve) for 3 seconds (1 trip detection logic). |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 3 seconds | Open or short in the vacuum switching valve (for EGR bypass valve) for 3 seconds (1 trip detection logic). |
|

| 1.INSPECT VACUUM SWITCHING VALVE (FOR EGR BYPASS VALVE) |
Inspect the vacuum switching valve (for EGR bypass valve) .
|
| ||||
| OK | |
| 2.CHECK VACUUM SWITCHING VALVE (FOR EGR BYPASS VALVE) (POWER SOURCE CIRCUIT) |
![]() |
Disconnect the vacuum switching valve (for EGR bypass valve) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| V7-1 - Body ground | Ignition switch to ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Vacuum Switching Valve (for EGR Bypass Valve)) |
Reconnect the vacuum switching valve (for EGR bypass valve) connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (VACUUM SWITCHING VALVE (FOR EGR BYPASS VALVE) - ECM) |
Disconnect the vacuum switching valve (for EGR bypass valve) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| V7-2 - E6-19 (ECBV) | Always | Below 1 Ω |
| V7-2 or E6-19 (ECBV) - Body ground | Always | 10 kΩ or higher |
Reconnect the vacuum switching valve (for EGR bypass valve) connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 5.REPLACE VACUUM SWITCHING VALVE (FOR EGR BYPASS VALVE) |
Replace the vacuum switching valve (for EGR bypass valve).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch to ON for 3 seconds.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||