NAVIGATION SYSTEM > Microphone Circuit between Microphone and Navigation Receiver Assembly |

| 1.CHECK NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the N5 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N5-18 (SGND) - Body ground | Always | Below 1 Ω |
| N5-19 (MIN-) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| N5-4 (MACC) - Body ground | Ignition switch ACC | 4 to 6 V |
| *a | Component without harness connected (Navigation Receiver Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY) |
Disconnect the N5 navigation receiver assembly connector.
Disconnect the M3 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N5-4 (MACC) - M3-4 (MACC) | Always | Below 1 Ω |
| N5-5 (MIN+) - M3-3 (MCO+) | Always | Below 1 Ω |
| N5-19 (MIN-) - M3-2 (MCO-) | Always | Below 1 Ω |
| N5-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| N5-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| N5-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| N5-18 (SNS2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||