Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Radio and Display Type)

REAR VIEW MONITOR SYSTEM (for Radio and Display Type) > TERMINALS OF ECU

for Preparation Click here



CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

E275626E04

  1. Disconnect the R21 and R20 radio and display receiver assembly connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R20-3 (ACC) - R20-7 (GND)
    GR - BR
    ACC signal
    Ignition switch off
    Below 1 V
    Ignition switch ACC
    11 to 14 V
    R20-4 (B) - R20-7 (GND)
    L-Y - BR
    Battery
    Always
    11 to 14 V
    R20-7 (GND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    R21-1 (IG) - R20-7 (GND)
    P - BR
    IG signal
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the R21 and R20 radio and display receiver assembly connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R37-12 (V+) - R37-24 (V-)
    W - R
    Display signal
    Ignition switch ON, shift lever in R
    Pulse generation (See waveform 1)
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens
    Pulse generation (See waveform 2)
    R37-11 (CA+) - R37-23 (CGND)
    B - Shielded
    Power source
    Ignition switch ACC
    5.5 to 7.05 V
    R37-23 (CGND) - Body ground
    Shielded - Body ground
    Shielding
    Always
    Below 1 V
    R21-2 (REV) - R20-7 (GND)
    R-Y - BR
    Reverse signal
    Ignition switch ON, shift lever in R
    7.5 to 14 V
    Ignition switch ON, shift lever not in R
    Below 1 V
    If the result is not as specified, the radio and display receiver assembly may have a malfunction.



  5. E159949E01
  6. Using an oscilloscope, check waveform 1.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    R37-12 (V+) - R37-24 (V-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    Ignition switch ON, shift lever in R



  7. E164781E01
  8. Using an oscilloscope, check waveform 2.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    R37-12 (V+) - R37-24 (V-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens