Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > USB Device or "iPod" cannot Charge


DESCRIPTION

This is the circuit that the navigation receiver assembly uses to supply power to devices connected to the USB jack of the No. 1 stereo jack adapter assembly. This diagnosis procedure is for when a USB device or "iPod" cannot charge.

WIRING DIAGRAM


E237859E02


INSPECTION PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the stereo jack adapter.

  1. Turn the ignition switch off.

    HINT:
    When this malfunction occurs, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the stereo jack adapter.

    OK:
    USB device or "iPod" charges.



NG
Go to step 2
OK

USB DEVICE OR "iPod" WAS DEFECTIVE 

2.CHECK NAVIGATION RECEIVER ASSEMBLY


    C225529E21
  1. Disconnect the N4 No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N4-1 (UPI) - N4-4 (UJSG)
    Always
    4.5 to 5.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 3
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the N9 navigation receiver assembly connector.

  1. Disconnect the N4 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N9-1 (USV1) - N4-1 (UPI)
    Always
    Below 1 Ω
    N9-4 (UGD1) - N4-4 (UJSG)
    Always
    Below 1 Ω
    N9-1 (USV1) - Body ground
    Always
    10 kΩ or higher
    N9-4 (UGD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)