BLOCKING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CRANK ENGINE FOR MORE THAN 10 SECONDS |
Check that the engine cranks for more than 10 seconds.
| Result | Proceed to |
| OK | A |
| NG (for 1KD-FTV) | B |
| NG (for 2KD-FTV) | C |
| NG (for 2TR-FE) | D |
| NG (for 1GR-FE) | E |
| NG (for 2TR-FBE) | F |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Based on the DTCs output above, try to force output of the same ECD system*1 or SFI system*2, engine immobiliser system and blocking system*3 DTCs by reproducing the monitoring conditions indicated by the DTCs.
| Result | Proceed to |
| DTC is not output. | A |
| ECD system DTC is output (for 1KD-FTV). | B |
| ECD system DTC is output (for 2KD-FTV) | C |
| SFI system DTC is output (for 2TR-FE). | D |
| SFI system DTC is output (for 1GR-FE). | E |
| SFI system DTC is output (for 2TR-FBE). | F |
| Engine immobiliser system DTC is output. | G |
| Blocking system DTC is output. | H |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in the problem symptoms table. | A |
| Fault is listed in the problem symptoms table. | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|