BLOCKING SYSTEM > Engine does not Start |

| 1.CHECK BLOCKING SYSTEM (SETTING) |
Check the blocking system setting.
| Result | Proceed to |
| Blocking system is set. | A |
| Blocking system is unset. | B |
|
| ||||
| A | |
| 2.CHECK TRANSPONDER KEY ECU ASSEMBLY (OUTPUT) |
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | T21-13 (EFIO) - T21-16 (GND) |
| Tool Setting | 10 V/DIV., 100 ms./DIV. |
| Condition | Ignition switch ON |
| Result | Proceed to |
| NG (stuck LOW) | A |
| NG (stuck HI) | B |
| OK | C |
| *1 | Waveform |
| *a | Component with harness connected (Transponder Key ECU Assembly) |
|
| ||||
|
| ||||
| A | |
| 3.REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Temporarily replace the transponder key ECU assembly with a new one (Refer to the Service Bulletin).
| NEXT | |
| 4.REGISTER ECU COMMUNICATION ID |
Register the ECU - ECM communication ID (Refer to the Service Bulletin).
| NEXT | |
| 5.CHECK WHETHER ENGINE STARTS |
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||
| 6.REGISTER ECU COMMUNICATION ID |
Register the ECU - ECM communication ID (Refer to the Service Bulletin).
| NEXT | |
| 7.CHECK WHETHER ENGINE STARTS |
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||