Home › ENGINE ยท 2KD-FTV › LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 ENGINE UNDER COVER


2. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

  1. Wipe the oil pan and drain plug.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    34 N*m{ 347 kgf*cm , 25 ft.*lbf }



3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the engine oil pressure switch connector.

  1. Using a 24 mm deep socket wrench, remove the engine oil pressure switch from the oil cooler cover.