AUTOMATIC TRANSMISSION SYSTEM > L4 Position Switch Circuit |

| 1.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND) |
![]() |
Disconnect the T5 No. 1 transfer indicator switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T5-2 - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector: (to No. 1 Transfer Indicator Switch) |
|
| ||||
| OK | |
| 2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH) |
![]() |
Remove the No. 1 transfer indicator switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| 1 - 2 | Pushed | Below 1 Ω |
| *a | Component without harness connected (No. 1 transfer indicator switch) |
| *b | Pushed |
| *c | Not pushed |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - ECM) |
Disconnect the T5 No. 1 transfer indicator switch connector.
Disconnect the E8 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T5-1 - E8-11 (L4) | Always | Below 1 Ω |
| T5-1 or E8-11 (L4) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||