Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV with i-ART)

AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV with i-ART) > L4 Position Switch Circuit

for Preparation Click here


DESCRIPTION

The No. 1 transfer indicator switch (the transfer L4 position switch) detects the gear position of the transfer shift lever. Moving the transfer shift lever to L4 turns the No. 1 transfer indicator switch (the transfer L4 position switch) on. Then the TCM cancels operation of the lock-up clutch.

WIRING DIAGRAM


C175018E18


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND)


    C237849E05
  1. Disconnect the No. 1 transfer indicator switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T5-2 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Transfer Indicator Switch)



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH


    C237865E01
  1. Remove the No. 1 transfer indicator switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Transfer Indicator Switch)
    *b
    Pushed
    *c
    Not pushed



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - TCM)
  1. Disconnect the T5 No. 1 transfer indicator switch connector.

  1. Disconnect the T36 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T5-1 - T36-15 (L4)
    Always
    Below 1 Ω
    T5-1 or T36-15 (L4) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TCM (Click here)