DIESEL THROTTLE BODY (w/ Glow Plug Controller) > ON-VEHICLE INSPECTION |
| 1. INSPECT DIESEL THROTTLE BODY ASSEMBLY |
Inspect the diesel throttle body (using the intelligent tester).
Turn the ignition switch to ON.
Turn the ignition switch off and wait for 5 seconds or more.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine / Data List / Actual Throttle Position.
Read the values.
| Engine Condition | Specified Condition |
| Ignition switch ON | -5 to 5% |
| Idling (after engine warmed up, at elevation near sea level) | 55 to 90% |
| Accelerator pedal fully depressed | -5 to 5% (value changes smoothly in transition) |
| Throttle Valve Condition | Actual Throttle Position |
| Fully closed | 100% |
| Fully open | 0% |
Enter the following menus: Powertrain / Engine / Data List / Throttle Close Learning Val. and Diesel Throttle Learn Status.
Read the values when the ignition switch is ON.
Inspect the diesel throttle body assembly (not using the intelligent tester).
Inspect the throttle valve operation visually.