DTC P1608 Engine Lack of Power |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| - | With the accelerator pedal fully depressed, engine output decreases for approximately 4 to 10 seconds due to a broken component in the intake or exhaust system, fuel system or cooling system or malfunction in one of those systems. (1 trip detection logic) |
|
![]() |
| 1.DTC OUTPUT (RECORD STORED DTC AND FREEZE FRAME DATA (PROCEDURE 1)) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Record the stored DTC and freeze frame data.
| NEXT | |
| 2.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1608) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| P1608 is output | A |
| P1608 and other DTCs are output | B |
|
| ||||
| A | |
| 3.DETERMINE CAUSE OF PROBLEM (CHECK FREEZE FRAME DATA AND SNAPSHOT) |
Determine the cause of the problem based on the freeze frame data recorded in Procedure 1.
| Judgment of Data List Values | Problem Cause | Trouble Area | Diagnosis Note |
| "MAF Low" in freeze frame data is ON | Intake air volume introduced via the mass air flow meter is insufficient and fuel injection volume remains suppressed |
|
|
| Judgment of Data List Values | Problem Cause | Trouble Area | Diagnosis Note |
| "Boost Pressure Low" in freeze frame data is ON | Actual boost pressure is lower than the target boost pressure and fuel injection volume remains suppressed |
| The possible malfunctioning areas can be narrowed down by checking "MAF/Estimate MAF Ratio" when "Boost Pressure Low" in the freeze frame data is ON.
|
| Judgment of Data List Values | Problem Cause | Trouble Area | Diagnosis Note |
| "MAF/Estimate MAF Ratio" in freeze frame data is 1.4 or more | Air that has passed through the mass air flow meter leaks, and the estimated intake air volume becomes less than the actual intake air volume. | Intake air leak due to intake pipe disconnection or cracks between the turbocharger sub-assembly and intercooler assembly or between the intercooler assembly and intake manifold. |
|
| "MAF/Estimate MAF Ratio" in freeze frame data is below 0.6 | Air that has not passed through the mass air flow meter is supplied to the engine, and the actual intake air volume becomes less than the estimated intake air volume. | Air entering due to intake pipe disconnection or cracks between the turbocharger sub-assembly and intercooler assembly or between the intercooler assembly and intake manifold. |
| Judgment of Data List Values | Problem Cause | Trouble Area | Diagnosis Note |
| "Common Rail Pressure Low" in freeze frame data is ON | Common-rail pressure remains below the target value. |
|
|
| Judgment of Data List Values | Problem Cause | Trouble Area | Diagnosis Note |
| "Engine Coolant Temp High" in freeze frame data is ON | Coolant temperature remains high (overheating) and fuel injection volume remains suppressed. |
| Cooling system including radiator assembly |
| NEXT | ||
| ||